Tirupati temple project case study
The Thirupati Balaji Main dom and Brahmchari ashram building were huge seepage & leakage issues and problems solves through our advanced Crystalline Roof treatment on right time.
An innovative concrete & waterproof solutions
Swimming Pool Waterproof
System Buildup
- Ensure that the surface is clean and free from all traces of loose materials, old coatings, curing membranes, release agents, laitance, oil, greases etc.
- Remove structurally unsound layers and surface containments by abrasive blast tracking or grinding.
- Arises Shall be rounded off and surface protrusions shall be ground down to ensure a workable surface.
- Use paintocon (A+B) a flexible high alumina cementitious 2 components (2:1) patching mortar for re-profiling defects on horizontal surfaces. Using paintocon should depend on the scope, particular conditions and requirement of the work.
- All tie rod holes and construction joints should be properly plugged in with PAINTOCON
- All Cracks (which is greater than 1mm) must be open as V groove and thoroughly repaired with Crack Healer Sealer.
- Coving between horizontal and vertical substrates at 45 degree & 12mm thick-100mm wide to be done with PAINTOCON
- After surface preparation and cleaning of the slab, do the ponding test of Roof/Slab, check the below area, mark the area where leakage or seepage is observed.
- As per the marking done on slab/roof based on leakage, open the crack as V groove, clean the area after crack opening.
- After cleaning the crack, pour Healer Sealer 007 in crack evenly, let the chemical be absorbed deep inside the crack.
- After 2-3 hours, again pour Healer sealer 007 deep inside the crack.
- After fully dried up, now fill the crack with Crack Healer Sealer material.
- Ensure that Crack healer sealer material is not hard or tight, slurry type material is recommended so that the material will go well inside the crack and fill all voids or porous gaps.
- Finally, with semisolid material crack can be filled completely and match to the existing surface of Roof/slab.
1
HEALER SEALER 007 a Crystalline Application
- After all the cracks are treated well with the designated method as described in 3.6, do the ponding again for 72 hours, if there is no leakage observed, further steps to be followed, else repeat 2 or as per the instruction of Engineer in Charge.
- If there is no leakage observed or ponding test is passed, next step is application of Healer sealer 007 throughout the roof.
- Apply 1st coat of Healer Sealer 007 throughout the roof including above filled cracks and leave it to dry, please ensure after application the roof or applicated area shall not be wet or damp. In case of rain please cover the area with tarpaulin sheet or any covering.
- Apply 2nd coat only after the 1st coat is completely dried up, preferably the next day.
- Protect the applicated surface area for any damage or wash out until it is totally dry.
Note
Healer sealer 007 is a crystallization liquid of specific gravity 1.09 is applied on the prepared surface. The sodium acetate formed during the chemical reaction penetrates inside the pores of the concrete and reacts with water to form active crystals to block the pores.2
PAINTO WETSHIELD CYSTALLINE CAPILARY SYSTEM
Providing & Applying Painto Wetshield Crystalline waterproofing slurry coat/or Putty consistency on RCC structure
The material having chemical resistance properties, seals shrinkage cracks up to 0.4 mm width, capable of preventing water dampness & seepages, Water permeability is Nil confirms to BS EN 12390 Part 8: 2000. Powder to water mixed at a ratio (5:2) 5 parts powder and 2 parts water, applied @ 1.5kg/m2 in 2 coats to achieve 1.0mm DFT on a cleaned surface free from all loose materials etc., complete. The finished coat to include surface preparation completely as per specification
Note
PAINTO WETSHIELD is a single component, surface-applied, crystalline capillary, 2 way waterproofing system and protect concrete in depth.3
Painto Wetshield Advantages
- Resists extreme hydrostatic pressure
- Becomes an integral part of the substrate
- Can be applied to the positive or the negative side of the concrete surface
- Highly resistant to aggressive chemicals
- Non-toxic / no VOCs
- Does not require sealing, lapping and finishing of seams at corners, edges or between membranes
- Not subject to deterioration
- Hardening time : Touch dry - 6 hour; Full cure 3 Days (Mist water curing suggested after each coat) Recoatings : 24 Hours
Note
Painto Wetshield is a unique chemical treatment for the waterproofing, protection, and repair of concrete. It consists of Portland cement, finely graded sand, and active proprietary chemicals. The active crystalline chemicals in Wetshield use into the substrate and react with moisture and the constituents of hardened concrete, resulting in a catalytic reaction. This reaction generates a non-soluble crystalline formation throughout the pores, capillary tracts, and cracks of the concrete, hence concrete itself becomes the water barrier.How our crystalline waterproofing system will be benefitted for you?
Your construction schedule shorten
Your workmanship reduced
Your repairs & damages cost reduced
You are savings when expenses reduces 30%
Permeability & durability increases
Warranty 10 years minimum
Products Used in Swimming pool Waterproof
Our Latest Project Case Study
Namma Metro project case study
The Yellow Line of Namma Metro is under construction and will form part of the metro rail network for the city of Bangalore, Karnataka, India. The 18.82 km line connects R.V. Road with Bommasandra and is fully elevated with 16 stations. Phase 1 (CSB-Bommasandra) - June 2023; 5 months' time; Phase 2 (RV Road-CSB) - December 2023; 11 months' time.Bangalore Namma metro station waterproofing integrated concrete treatment with Healer Sealer 007 & Roof/Rain Healer Sealer.
Bangalore high court project CS
Attara Kacheri in Bangalore, India is the seat of the principal bench of the Karnataka High Court, the highest judicial authority in the state of Karnataka. It is a 125 years old, neoclassical red-painted stone and brick building in Cubbon Park, located on Dr. B. R. Ambedkar Road opposite the Vidhana Soudha. Bangalore High court waterproofing roof & concrete treatment with Healer Sealer 007 & Roof & Rain Healer Sealer.
KR market project case study
K R Market (Krishnarajendra Market), also known as City Market, is the largest wholesale market dealing with commodities in Bangalore, India since 1928. A new concrete 3-story structure was erected in the 1990s between the two older buildings. KR Market, City market waterproofing treatment through customize design with Healer Sealer 007 & special co-oplymer mix solutions.
